OpenSprinkler and accessories – CONFIGURATOR

For an outdoor installation, the OpenSprinkler a waterproof case.
If you only the OpenSprinkler want to install, then the smallest housing is sufficient. You should choose a larger case for additional components.
DIN rail power pack recommended. Housing includes matching DIN rails, brackets, screws, watertight glands and a OpenSprinkler-Connection cable.

Only if you select a housing or a DIN rail adapter, the DIN rail power supplies will appear in the next step

For OpenSprinkler AC and OSPi for installation on a DIN rail, such as with the OpenSprinkler Housing
Choose the capacity based on the valves to be opened AT THE SAME TIME:
1A 24VA for 2 valves
1,5A 35VA for 5 valves
2A 50VA for 8 valves
Since 3A is the maximum current that the OpenSprinkler can handle, only choose the larger power supplies if you have other components, e.g. a second OpenSprinkler want to supply electricity.

12VDC 30W or 60W power adapter for OpenSprinkler DC or latch.

Already with 30W you can open 8 valves at the same time
with 60W even 16 valves

The right cable to connect a DIN rail power supply DC with the OpenSprinkler DC or latch to connect. Not suitable for AC - here you use a normal 12V cable.
When you purchase an IP65 housing, the cable is already included.

For locking the housing with a key

The Hunter Rain-Clik reacts particularly quickly to the onset of rain. This reliably ends an ongoing irrigation or does not start it at all.
Just connect the sensor to SEN1 + GND

Ideal for raised beds or greenhouses.
Please note that with a soil moisture sensor you only monitor one point in your garden. Therefore, this is only suitable for small, contiguous areas.
a) With A2D adapter (free of charge):
The necessary A2D adapter for the OpenSprinkler is supplied free of charge.
Note: Unfortunately, the also integrated temperature sensor cannot be connected.
b) With Analog Sensor Board (only OpenSprinkler AC/DC/Latch)
Soil moisture AND temperature can be read out and saved.
The watering duration can be adjusted based on the soil moisture.
Graphic evaluation of the measured values
In the next step you can add this (not OSPi)

The "Analog Sensor Board" allows the reading of 8 analog sensors in the voltage range 0..3,3V. The ADS1115 analog-to-digital converter processes the signals to 16-bit with the highest precision.
So it is ideal for Truebner SMT50 designed, which can measure soil moisture and soil temperature.
Firmware OS 2.3.0 must be installed for the board to be recognized.

Expands the controllable OpenSprinkler Zones by 16 more zones.
Up to 4 zone expanders are connected to one OpenSprinkler connectable.
For OSPi choose the 2.1 AC
Otherwise for AC the 3.0 AC, DC the 3.0 DC and latch the 3.0 latch