The Waveshare instructions can be found here: https://www.waveshare.com/wiki/RS485_TO_ETH_(B) In principle, you just have to connect the Waveshare and install the software. Then set it up as follows: Start VirCom, “Device Management”, then the device should appear. Configure the device with “Edit Device”. You can freely choose the port, e.g. 502 or 8899 or completely different. Important: Firmware 2.3.0.(135) or [...]
Category Archives: General
The USR-W610 has the advantage that it also comes with the right power connection for the sensors. Up to 32 sensors can be connected to a Modbus connection of a USR-W610 (a more powerful power supply unit may be necessary at the maximum expansion level). Currently, only the Truebner SMT100, the Truebner Aquaflex and the Truebner T100 in RS485 Modbus versions supported. [...]
Here's the report: Opensprinkler Irrigation computer in the test
1. Activating the UI Firmware version 2.3.0(x) with Analog Sensor API extension is required. so that you OpenSprinkler To use the analog sensor configuration, the UI configuration must be adjusted. Please note: There is no manufacturer support (from the USA) for the modified firmware, only via the German support page! a) OpenSprinkler 3.2: Determine […]
Note Supported from firmware 2.2.0 OpenSprinkler 3.x remote access via OTC tokens. Please note that this is only for OpenSprinkler-Hardware 3.x is available, it is NOT available for OpenSprinkler-Hardware 2.x or OpenSprinkler Pi / Beagle / demo. So this article is only for OpenSprinkler 3.x relevant. For OpenSprinkler 3 requires a firmware update. Introduction From firmware […]
Coming soon: The new OpenSprinkler Analog sensor expansion board! Features: 8 analog sensor inputs with the range 0..4V Outputs: 5V and GND for powering the sensors (7 additional 3,5V) Can also be combined with up to 4x zone expanders Maximum ONE analog sensor board per OpenSprinkler 3/3.2 16 bit digital analog to digital converter (2x ADS1115) Compatible e.g. […]
We are asked the same question over and over again: how many solenoid valves can it handle OpenSprinkler open at the same time. But the answer is always "it depends", because the solenoid valves from different manufacturers have different performance values. I got to the bottom of the matter and did some tests as an example. a) With the OpenSprinkler AC and the […]
For the OSPi (OpenSprinkler Raspberry Pi version) a suitable housing is now available. The case is 3D printed and a perfect fit. Features: 3D printed 100% match OSPi Available in 2 different colors for the common Raspberry PI 3/4/5 or Zero-W! Stable base plate The green plugs can still be easily removed and plugged in again - for a […]
In the summer of this year, we, the operators of the OpenSprinkler weather service, a strange effect: Apparently the weather service is overloaded. The reason was found quickly, there were DDOS attacks against the OpenSprinkler Weather service running servers that flooded the weather service with nonsensical information, thereby restricting its use. the OpenSprinkler Computers then got instead of the weather data […]
OSPi is available again! However, we can only offer the variant without a housing - but at a lower price. From November we will offer our own housing - 3D printed.